Fitting the output of the Linear Circuit Builder
Posted: Sun Aug 26, 2018 12:22 pm
Dear Ted,
I encountered a problem when fitting the voltage-response of a node with the multiple run fitter. I could do everything as expected until a certain point, which was the implementation of more than 12 parallel RC components into my reduced circuit. After the 13th, the Linear Circuit Builder said that I encountered inconsistencies. This always happened at the 13th point, with ordiary values as well, so I stopped at 12. However, when I started fitting the voltage of a certain node, which I could do before the 12 RC components (with a reduced circuit), the multiple run fitter started to encounter some problems. The regular error massage was: Section access unspecified.. This always happens, no mather what point I chose as variable to fit, and at the same time, I can plot the desired variable at the current graph window. I would greatly appreciate if yo could help me with this problem.
Thanks,
Viktor
I encountered a problem when fitting the voltage-response of a node with the multiple run fitter. I could do everything as expected until a certain point, which was the implementation of more than 12 parallel RC components into my reduced circuit. After the 13th, the Linear Circuit Builder said that I encountered inconsistencies. This always happened at the 13th point, with ordiary values as well, so I stopped at 12. However, when I started fitting the voltage of a certain node, which I could do before the 12 RC components (with a reduced circuit), the multiple run fitter started to encounter some problems. The regular error massage was: Section access unspecified.. This always happens, no mather what point I chose as variable to fit, and at the same time, I can plot the desired variable at the current graph window. I would greatly appreciate if yo could help me with this problem.
Thanks,
Viktor